Time / Date: 10/24/2022 8:39:56
JSP ID: 134
Scope of Work: Pm for 74-AC-025
Work Order: 299102
Building:
Person in Charge: Gerald Fowler
Lead / Supervisor: Delgado, Alex
Logged Email: gdfowler@lbl.gov
Division: Facilities
QEW Level: QEW 2
Modes of Work: Mode 0 - Electrically Safe Work Condition, Mode 1 - LOTO & Zero Voltage Verification
Second Person Requirement: Standby Person
Second Person Identified: Antonio Collado
List Other Participants:
Affected Persons Notified: Yes
Switching: Non-Hazardous Switching
Panel / Equipment ID: E47A2A2A22A/74-AC-025
System Information Review: Arc Flash Labels
Control of Hazardous Energy: Simple LOTO
Equipment Condition: Properly installed, Properly maintained, All doors and covers closed and fully latched, No signs of impending failure, Not energizing equipment for the first time, or after electrical repair

Sequence of Job Steps

List basic sequence of steps from start to finish.

Loto out unit perform pm

Control of Work Area

Minimum Approach Boundary: 42 inches
Barricade Tape / Attendant: Notice

Shock Risk Assessment

System Voltage: 120/208 V ac
Limited Approach Boundary: 42 inches
Restricted Approach Boundary: 12 inches
Will the hands enter the RAB: Yes
Voltage Glove Class: 0
Will any other part of the body enter the RAB: No

Arc Flash Risk Assessment

Incident Energy: .008 cal cm2 cal/cm2
Arc Flash Boundary: 3 inches
Working Distance: 18 inches
Arc Flash PPE Level: 1
Incident Energy Reduction Measures: 0

Capacitor Hazards

Capacitor Bus Voltage: Na
Capacitor total stored energy (joules): NA
Discharge wait time (minutes): Na

Emergency Response Plan

Nearest Landline Location: Building lobby/ conference room
Emergency Number to Call: 6999/7911
Sufficient cell phone signal? Yes
Clear exit path? Yes
AED Location: Building lobby
Fire Extinguisher Location: On roof
Contact release method available and tested: Upstream breaker or switch

Environmental Conditions

Does the environment present additional hazards that should be addressed?

None

Error Precursors

Task Demands: Repetitive actions or monotony
Work Environment:
Individual Capabilities:
Human Nature: Assumptions, Complacency/overconfidence
Error Precursor Mitigations:

Na

PPE Inspections

Notes / Other

Perform Job Breifing

PIC Conducts the Job Briefing. Cover all the contents of the Job Safety Plan.

A Job Briefing at a minimum must include:
  1. Detailed Scope of Work
  2. Shock and arc flash hazards for each task
  3. Controls to mitigate the hazards (procedures, precautions, energy source controls, PPE requirements)
  4. Work area controls (barricades, signs, attendants)
  5. Emergency Response Plan

Rev 2023.08.22.1
Form Content and Feedback Contact: Michael Rose -- mvr@lbl.gov