QEW 1 / 2 / 3 Job Safety Plan
Print Form
Back to Index
Time / Date:
1/26/2024 9:46:21
JSP ID:
2129
Scope of Work:
Remove indicated out of service conductors SHB cables
General Information
Work Order
358455
Building
6
Person in Charge
E Combs
Lead / Supervisor
Keusch, Justen
Logged Email
ccryken@lbl.gov
Division
Facilities
Work Planning
Modes of Work
☑ Mode 0 - Electrically Safe Work Condition
QEW Level
QEW 2
Second Person Requirement
Not Required
Second Person Identified
Other Participants
Chris Nelson, Robert Ralph
Affected Persons Notified
N/A
System / Equipment
Switching
No Switching Required
Panel / Equipment ID
N/A
System Information Review
☑ Linac cables labeled at BA racks
Control of Hazardous Energy
LOTO Not Required (Mode 2 or 3 only)
Equipment Condition
☑
Sequence of Job Steps
List basic sequence of steps from start to finish
Walkjob with supervisor. Perform work
Control of Work Area
Minimum Approach Boundary
Barricade Tape / Attendant
Shock Risk Assessment
System Voltage
No Shock Hazard Present
Limited Approach Boundary
None
Restricted Approach Boundary
None
Will the hands enter the RAB
No
Voltage Glove Class
Not Required
Will any other part of the body enter the RAB
No
Arc Flash Risk Assessment
Incident Energy
N/A cal/cm2
Arc Flash Boundary
N/A
Working Distance
No Arc Flash Hazard Present
Arc Flash PPE Level
Minimum PPE for Electrical Work
Incident Energy Reduction Measures
Not Required
Capacitor Hazards
Capacitor Bus Voltage
Capacitor Total Stored Energy (Joules)
Discharge Wait Time (Minutes)
Emergency Response Plan
Nearest Landline Location
All over storage ring pit
Emergency Number to Call
911
Sufficient Cell Phone Signal
Yes
Clear Exit Path
Yes
AED Location
Bldg 88 first floor
Fire Extinguisher Location
Multiple inside storage ring pit
Contact Release Method Available and Tested
Environmental Conditions
Does the environment present additional hazards that should be addressed?
None
Error Precursors
Task Demands
Work Environment
Individual Capabilities
Human Nature
Error Precursor Mitigations
N/A
PPE Inspections
☑ Safety glasses (ANSI Z87)
☑ Non-melting footwear that fully covers the feet
☑ Gloves
Notes / Other
Perform Job Briefing
PIC Conducts the Job Briefing. Cover all the contents of the Job Safety Plan.
A Job Briefing at a minimum must include:
Detailed Scope of Work
Shock and arc flash hazards for each task
Controls to mitigate the hazards (procedures, precautions, energy source controls, PPE requirements)
Work area controls (barricades, signs, attendants)
Emergency Response Plan
