QEW 1 / 2 / 3 Job Safety Plan

General Information

Work Order

W0304234

Building

91

Person in Charge

Sayee Chea

Lead / Supervisor

Keusch, Justen

Logged Email

schea@lbl.gov

Division

Facilities

Work Planning

Modes of Work

☑ Mode 0 - Electrically Safe Work Condition
☑ Mode 1 - LOTO & Zero Voltage Verification

QEW Level

QEW 2

Second Person Requirement

Not Required

Second Person Identified

Frank Hampton

Other Participants

Arnel Jugarap

Affected Persons Notified

Yes

System / Equipment

Switching

Non-Hazardous Switching

Panel / Equipment ID

671A2A3A

System Information Review

☑ Panel Schedules

Control of Hazardous Energy

Simple LOTO

Equipment Condition

☑ Properly installed
☑ Properly maintained
☑ All doors and covers closed and fully latched
☑ No signs of impending failure
☑ Not energizing equipment for the first time
☑ or after electrical repair

Sequence of Job Steps

List basic sequence of steps from start to finish

Identify panel/breaker, identify proper PPE, notified affected people, applied LOTO, inspect tools and, gloves and PPE, perform ZVV, installed fixture, brought power back on after informing affected people.

Control of Work Area

Minimum Approach Boundary

Barricade Tape / Attendant

Attendant

Shock Risk Assessment

System Voltage

277/480 V ac

Limited Approach Boundary

42 inches

Restricted Approach Boundary

12 inches

Will the hands enter the RAB

Yes

Voltage Glove Class

0

Will any other part of the body enter the RAB

No

Arc Flash Risk Assessment

Incident Energy

0.78 cal/cm2

Arc Flash Boundary

14 inches

Working Distance

18 inches

Arc Flash PPE Level

Minimum PPE for Electrical Work

Incident Energy Reduction Measures

0

Capacitor Hazards

Capacitor Bus Voltage

Capacitor Total Stored Energy (Joules)

Discharge Wait Time (Minutes)

Emergency Response Plan

Nearest Landline Location

Cell phone

Emergency Number to Call

5104867911

Sufficient Cell Phone Signal

Yes

Clear Exit Path

Yes

AED Location

Lobby

Fire Extinguisher Location

Hallway

Contact Release Method Available and Tested

Voltage gloves

Environmental Conditions

Does the environment present additional hazards that should be addressed?

None

Error Precursors

Task Demands

Work Environment

Individual Capabilities

Human Nature

Error Precursor Mitigations

Review scope of work

PPE Inspections

☑ Safety glasses (ANSI Z87)
☑ Arc-rated clothing (flash suit
☑ daily wear) including face shield
☑ balaclava
☑ hood.
☑ Hearing protection
☑ Rubber insulating gloves and leather protectors
☑ Non-melting footwear that fully covers the feet
☑ Removal of conductive articles
☑ Insulated tools
☑ Multimeter and other electrical test instruments

Notes / Other

Perform Job Briefing

PIC Conducts the Job Briefing. Cover all the contents of the Job Safety Plan.

A Job Briefing at a minimum must include:

Detailed Scope of Work
Shock and arc flash hazards for each task
Controls to mitigate the hazards (procedures, precautions, energy source controls, PPE requirements)
Work area controls (barricades, signs, attendants)
Emergency Response Plan