QEW 1 / 2 / 3 Job Safety Plan

General Information

Work Order

401304

Building

B74A

Person in Charge

Larry Antles

Lead / Supervisor

Delgado, Alex

Logged Email

leantles@lbl.gov

Division

Facilities

Work Planning

Modes of Work

☑ Mode 0 - Electrically Safe Work Condition
☑ Mode 1 - LOTO & Zero Voltage Verification

QEW Level

QEW 2

Second Person Requirement

Not Required

Second Person Identified

Other Participants

Affected Persons Notified

N/A

System / Equipment

Switching

Non-Hazardous Switching

Panel / Equipment ID

47a5a9a1a/B74A AC 001

System Information Review

☑ Panel Schedules

Control of Hazardous Energy

Complex LOTO (requires LP, CLP, FLP)

Equipment Condition

☑ Properly installed
☑ All doors and covers closed and fully latched
☑ No signs of impending failure
☑ Not energizing equipment for the first time
☑ or after electrical repair

Sequence of Job Steps

List basic sequence of steps from start to finish

LOTO ZVV equipment check and tighten electrical

Control of Work Area

Minimum Approach Boundary

42”

Barricade Tape / Attendant

Danger - Red

Shock Risk Assessment

System Voltage

120/208 V ac

Limited Approach Boundary

42 inches

Restricted Approach Boundary

12 inches

Will the hands enter the RAB

Yes

Voltage Glove Class

0

Will any other part of the body enter the RAB

No

Arc Flash Risk Assessment

Incident Energy

No arc flash hazard cal/cm2

Arc Flash Boundary

No arc flash hazard

Working Distance

18 inches

Arc Flash PPE Level

2

Incident Energy Reduction Measures

0

Capacitor Hazards

Capacitor Bus Voltage

No

Capacitor Total Stored Energy (Joules)

No

Discharge Wait Time (Minutes)

No

Emergency Response Plan

Nearest Landline Location

B74A Hallway

Emergency Number to Call

6999

Sufficient Cell Phone Signal

Yes

Clear Exit Path

Yes

AED Location

AT unit

Fire Extinguisher Location

On service truck

Contact Release Method Available and Tested

Voltage gloves

Environmental Conditions

Does the environment present additional hazards that should be addressed?

Fall hazard

Error Precursors

Task Demands

Work Environment

Individual Capabilities

Human Nature

Error Precursor Mitigations

Electrical ladders slips trips and falls

PPE Inspections

☑ Safety glasses (ANSI Z87)
☑ Arc-rated clothing (flash suit
☑ daily wear) including face shield
☑ balaclava
☑ hood.
☑ Hearing protection
☑ Rubber insulating gloves and leather protectors
☑ Non-melting footwear that fully covers the feet
☑ Removal of conductive articles
☑ Insulated tools
☑ Multimeter and other electrical test instruments

Notes / Other

Perform Job Briefing

PIC Conducts the Job Briefing. Cover all the contents of the Job Safety Plan.

A Job Briefing at a minimum must include:

Detailed Scope of Work
Shock and arc flash hazards for each task
Controls to mitigate the hazards (procedures, precautions, energy source controls, PPE requirements)
Work area controls (barricades, signs, attendants)
Emergency Response Plan